The 1-1 Room Heat transfer kit is designed to transfer warm air from one room to another room which is nearby. The kit comes with everything you need to install including ducting, an inline fan and intake/outlet vents.
1-1 Room Heat Transfer Kit Includes:
1x 150mm Mixflow inline fan with lead and plug.
2 x 6m length of R 1.0 Rated 150mm Insulated ducting
2 x 150mm plastic white cone vents
1 x Hanging tape
1 x Duct Tape
Inline Fan Specs
- Motor Type: Mixflow
- Capacity: 520 m3/hr (144.44 l/s)
- Motor Power (Wattage): 60w
- Noise Level at 3m: 44 dB(A)
- Duct Size: 150mm
About This Kit
The 1-1 long room heat transfer kit is designed to be relatively easy to install. First you will need to install the intake vent inside the room with the heat source. You can then install the outlet cone vent in the room you wish to transfer the heat to. This kit comes with 12m of insulated ducting, so please ensure the vents are no more than 12m apart.
You can then install the motor inside the roofspace. The fan in this kit comes pre wired to a lead and plug, meaning it will simply plug into a powerpoint in the roofspace. Once the fan is in position you can run the insulated duct from the intake vent to the motor and then to the outlet vent. Use the supplied duct tape to ensure everything is connected securely and use the hanging tape to ensure the ducting does not sag. The duct is supplied in 6m lengths, which you will need to cut depending on the length of the inlet and outlet.
The kits can be installed by the client as it is relatively easy to install. Some handyman skills are required to make holes in the plaster, etc. An electrician is needed to provide power to the fan (or a power point if you do not already have one) and a switch, also to install a thermostat if required.